The Effects of Cold Rolling on the Microstructural and Spall Response of 1100 Aluminum

Report No. ARL-RP-463
Authors: C. L. Williams; C. Q. Chen; K. T. Ramesh; D. P. Dandekar
Date/Pages: September 2013; 18 pages
Abstract: As received 1100-O aluminum was cold rolled (CR) to 30%, 70%, and 80% reduction, respectively, to study the effects of microstructural evolution on the spall response using plate impact experiments. Previous results show a sharp increase in pullback velocity for 1100-O aluminum with increase in peak shock stress between 4.0 and 8.3 GPa due to hardening, followed by a decrease for peak shock stresses up to 12.0 GPa possibly due to softening. This maximum was not observed for the 30% CR, which showed only an increase in pullback velocity over the shock stress range of 4.012.0 GPa due to hardening (net increase in dislocation density). For the 70% CR aluminum, no change was observed in the pullback velocity over the range tested (4.011.0 GPa) probably due to saturation in dislocation density. Similar observations were made for the 80% CR, that is, no change was observed in the spall response between 4.0 GPa and 11.0 GPa. However, variations were observed in the spall response for the 80% CR, and these variations are attributed to material inhomogeneity possibly caused by increased cold rolling beyond saturation. The results also show a significant increase in Hugoniot Elastic Limit with increase in percent cold rolling.
Distribution: Approved for public release
  Download Report ( 7.872 MBytes )
If you are visually impaired or need a physical copy of this report, please visit and contact DTIC.
 

Last Update / Reviewed: September 1, 2013